Service

Irrigation and Sprinkler Leak Detection in Lynnwood

A sprinkler system can leak for weeks underground, especially in summer when the lawn is green anyway. Most leaks are at valves, heads or buried lateral lines, and each zone can be tested on its own.

Key takeaways
  • If the meter stops when the irrigation supply is shut off, the leak is in the sprinkler system.
  • Common leak points: zone valves, the backflow device, broken heads and buried lateral lines.
  • A leak on the main line runs all the time; a leak on a lateral line only while that zone waters.
  • Each zone is tested separately, then the leak is pinpointed with pressure and acoustic checks.
  • Winterize the system before freezing weather to prevent split pipes and backflow damage.

Last reviewed October 26, 2026

Pop-up lawn sprinkler spraying water across a suburban front lawn
Illustration: a lawn sprinkler zone running.
Plan view of a yard sprinkler system with backflow device, valve box and lateral lines, with a soggy area over a leaking buried line
Plan view: a leak on a buried lateral line often shows up as one soggy spot.

Signs of an irrigation leak

  • Soggy or sunken spot in the lawn, or water bubbling up in one place.
  • One zone with weak spray or heads that don't pop up fully.
  • Water seeping from a valve box.
  • Water meter moving after all zones are off.
  • A higher summer bill than in past years.

Is it the sprinklers or the house?

Turn off everything inside the house and watch the meter. Then close the irrigation supply valve (often near the backflow device). If the meter stops, the leak is in the sprinkler system. If it keeps moving, the leak is on the house plumbing or the service line. Our meter check guide shows each step.

Where sprinkler systems leak

PartHow it shows up
Main line (before zone valves)Leaks all the time, even when no zone is running
Zone valveWater in the valve box, or a zone that won't shut off fully
Lateral lineSoggy spot that appears when that zone runs
Heads and risersGeysers, weak spray, puddles around a head
Backflow deviceDripping or spraying at the assembly, often after a freeze

How the leak is located

  1. Isolate

    The house and irrigation supply are separated with the meter as the gauge.

  2. Zone by zone

    Each zone is run alone to see where pressure drops or water surfaces.

  3. Pressure test

    The main line is checked with zones closed to see if it holds.

  4. Pinpoint

    Line tracing and acoustic listening narrow down buried leaks before digging.

Detection versus repair

Leak detection finds the faulty zone and spot. Replacing heads, valves or a section of line is a separate job for a landscape or irrigation contractor. Backflow assemblies in Washington are subject to testing requirements set by the water purveyor; ask your utility.

What to check before you call

These details help narrow down the zone on the first call:

  • Which zone. Note which zone runs when the soggy spot appears, or whether the spot is wet all the time.
  • Controller settings. Recent schedule changes, a zone stuck on, or a controller that lost its program after a power cut.
  • The valve boxes. Water standing in a valve box, or a zone that will not shut off fully, points to that valve.
  • Recent freezes. A backflow device or exposed pipe that cracked in a freeze often shows up at the first spring start-up.

What affects the cost

Cost depends on the number of zones, the size of the lot, whether the leak is on the main line or a lateral, and how deep or hard to reach the buried line is. Locating the leak is priced separately from digging up and replacing a section of line, which is a job for a landscape or irrigation contractor.

Irrigation leaks in Lynnwood yards

Lynnwood's dry summer months are when sprinkler systems run most, and a leak in an irrigation line can raise a bill quickly. Signs include soggy patches on dry days, a zone with weak heads and a meter that moves when the system is off. In the fall, lines that are not drained properly can crack in the first freeze and leak when the system starts again in spring.

Some Lynnwood-area properties have a separate irrigation meter. If yours does, check which meter is moving. For leaks between the meter and the house, see water line leak detection, or go back to leak detection in Lynnwood.

Irrigation questions

When should I winterize my sprinklers?

Before the first hard freeze. Water left in lines and the backflow device can split them.

Can an irrigation leak qualify for a bill adjustment?

Check your utility's rules. See our Lynnwood leak adjustment guide.

How do I find the irrigation shut-off?

It is usually near the backflow device, often close to the house or meter. Some systems have a valve in a box in the yard.

Why does only one zone lose pressure?

A leak or blockage on that zone's lateral line or a failing valve affects only that zone. Other zones run normally because they are on separate lines.

Can a sprinkler leak waste water in winter?

Yes, if the system was not winterized and the main line leaks, it can run all winter unnoticed. Winterize before the first hard freeze, and check the meter over winter if the system stays charged.

Should I mark sprinkler lines before anyone digs?

Yes. Mark the approximate routes of lateral lines and valve boxes, and call 811 before digging anywhere in the yard so buried utilities are located too.

Related services

See water line leak detection, pool and spa leak detection or the home page.

Think you have a hidden leak?

Call and describe the symptoms. You will get straight answers about what testing involves and what it may cost before anyone visits.

Call nowContact